Voyage i20

Technical Specifications

Power output @ 1% THD: 120 Watts into 8 Ohms, both channels

Power output @ 1% THD: 240 Watts into 4 Ohms, both channels

Power output @ 1% THD: 480 Watts into 2 Ohms, one channel

Power output tolerance: Voltage stabilisation enables repeatable power output regardless of mains voltage or load. Current limited

Continuous max output current: >10A (sine wave), Current limited

Peak output current: +/-26 Amps into 0.5 Ohm load for 100ms – current limited

THD and Noise: <0.002% – 20 Hz to 20 kHz @ 2/3 rated power 8 Ohms

Signal to Noise Ratio: 102dBA Line input

Frequency Response: 1Hz to 100 kHz, +/-2dB

Power amp gain: 33.4dB (x 47) un-balanced

Pre-amplifier analogue gain: 0dB (x1) default.

Optional pre-amp gain or bypass: 3dB, 6dB, 9dB, 12dB, pre-selectable on inputs 1 to 4

Input sensitivity: 659mV for full power into 8 Ohms with 0dB pre-amp gain

Crosstalk: >80dB at 1 kHz

DC offset: < +/-5mV

Pre-Amp Inputs: 4 x RCA (un-balanced) and 1 x XLR (balanced)

Pre-amp outputs: 1 x RCA (unbalanced) and electronically buffered

Pre-amp output impedance: 100 Ohms

Plug-in Phono options: Input 1 changes to Phono with Sequel mk4 MM Phono fitted

Digital inputs: 2 x SPDIF Co-Axial – (192kHz, 24-bit)

2 x TOSLINK optical – (192kHz, 24-bit)

USB class 2 audio: PCM up to 384kHz, 32-bit. DSD 64 and 128

Bluetooth:  aptX HD

IR BUS IN: External IR sensor extender

IR BUS OUT: Daisy chain to another Voyage device

Loudspeaker Outputs: 4mm binding posts with rear and side entry, plus spade lug

Speaker output impedance: <0.02 Ohms 20Hz to 20 kHz (Damping factor >400)

Headphone Output socket: 6.3mm stereo jack socket

Headphone output impedance: <22 Ohms, suitable for headphone 12 – 600 Ohms

Mains voltage range

230V nominal.  Working range – 170V – 265V AC – 50Hz

115V nominal.  Working range – 85V   – 140V AC – 60Hz

Factory set to either 230V or 115V. Not user adjustable

Mains fuse type and rating: T10AL 250V – 5 x 20mm glass cartridge fuse

10 Amp, Time-lag, or Anti-surge, rated at 250V

Ground connections: Turntable grounding post next to Line 1 / Phono

Ground Lift: A 2-way switch is located under the chassis on the right

Finish colours: Silver or Black front panel. The outer cover is black

Power Consumption: Idle, Max, Standby <20 Watts, 600 Watt, 0.5Watts

Auto Standby: The amp will switch off after 30 minutes with no signal

Auto Standby Menu: Status and options controlled in Menu

Power supply fuse: T10AL 250V = 10 Amp, Time-Lag, rated at 250V, 5 x20mm

Weight: 9kgs (20 lbs) net

Size W/H/D: 43 x 8 x 35 cm (17 x 3 x 13.8”) including feet, knobs, and terminals